sharehost.blogg.se - Dbx driverack 260 crossover

#DBX DRIVERACK 260 CROSSOVER DRIVER#
#DBX DRIVERACK 260 CROSSOVER FULL#
#DBX DRIVERACK 260 CROSSOVER PROFESSIONAL#

Compact, ultra-lightweight, the PRX712 uses JBL's tour tested technology throughout so you can trust it to deliver a lifetime of reliable performance. Powering the PRX712 is a 1500 Watt high performance, exceptionally low distortion biamplification system engineered to deliver clean power with maximum headroom to efficiently deliver smooth high frequencies and rich, deep bass response even at very high sound power levels. Differential Drive technology incorporates lower mass in the ferrite magnet for reduced weight while maximizing power amp efficiency for greater heat dissipation and increased power handling. The PRX712 is the next step in the highly successful PRX Series and introduces the first use of JBL's patented Differential Drive Technology with ferrite drivers.

Analog Inputs: (2) Female XLR line inputs.

Setup Wizard with JBL speaker and Crown Power Amplifier Tunings.

#DBX DRIVERACK 260 CROSSOVER FULL#

Full Bandpass, Crossover, and Routing Configurations.2.7 Seconds of Alignment and Zone Delay.Output Connectors: 1 male XLR balanced output.Input Connectors: 2 x Balanced XLR / 1/4 inch input, 2 x unbalanced RCA input.Grille: Powder coated, Obsidian, 16 gauge perforated steel with acoustical transparent black cloth backing.Transport: 1 x injection molded handles with backing cup.Suspension / Mounting: Dual 36 mm pole socket, 12 x M10 Suspension Points.Enclosure: Asymmetrical, 18 mm, plywood.

#DBX DRIVERACK 260 CROSSOVER DRIVER#

HF Driver: 1 x JBL 2408H-2 37.5 mm (1.5 in) annular polymer diaphragm, neodymium compression driver.LF Driver: 1 x JBL 272G 305mm (12 in) woofer.Input Impedance: 20K Ohms (balanced), 10K Ohms (unbalanced).

Dynamic Control (Input): dbx Type IV™ limiter circuit.

Signal Indicators: Limit: Yellow LED indicates peak output has been reached and dsp limiter is acting, Signal: Green LED indicates signal present, Power/Standby : Blue indicates system has power and ready to pass audio, Red indicates system has power but is in a power saving mode and will not pass audio.

Frequency Response (☓ dB): Main: 55.7 Hz – 18.2 kHz.Cloth backed, dent-resistant 16 gauge steel grilles.Lightweight poplar plywood cabinets made structurally sound with tongue and groove joints and protected by JBL's tour proven DuraFlex™finish.Integrated M10 suspension points for easy setup.Injection molded handle with backing cup for easy transport.Integrated 36 mm pole mount socket with angle down tilt.Multi-angle enclosure for main PA or floor monitor applications.

#DBX DRIVERACK 260 CROSSOVER PROFESSIONAL#

Professional XLR-1/4" combination inputs, RCA inputs, and XLR loop-through.Line level and direct microphone input capability.DSP input section, crossover, dynamic limiting, component optimization, selectable system EQ.Optimized EQ for monitor or front-of-house applications.JBL designed waveguide for accurate coverage.1.5" diameter next generation JBL neodymium compression driver.12" Differential Drive® low-frequency driver for low-distortion and higher SPL.JBL PRX712 Speakers & dbx DriveRack 260 Bundle Overview